|
The Agilent E5394A soft touch connectorless probe provides a convenient, reliable means of probing your target system without the need for a connector. The probe has a very small footprint making it easy to use in designs that are tight on space. Because this probe uses Agilent’s soft touch connectorless technology there is no need for special plating or preparation of the probe site. This probe can be used with any Agilent logic analyzer with a 40-pin cable connector. - 34 channels: 32 single-ended data, 2 single-ended clock
- < 0.7 pF equivalent load capacitance
- > 2.5 Gb/s maximum data rate
- Measure signals with as little as 500 mV p-p signal amplitude
- Requires up-front design of original soft touch connectorless footprint on PC board (no connector on the target board)
- Micro spring-pin technology provides reliable contact to signal pads even when probing uneven or contaminated board surfaces
- Top-side retention module eliminates need to access back of the board
- For logic analyzers with 40-pin cable connectors
- All board surfaces, including lead free
- Original soft touch connectorless footprint
|
