The Model 3000W1000 is a self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull circuitry is utilized in all high power stages in the interest of lowering distortion and improving stability. The Model 3000W1000, when used with a sweep generator, will nominally provide over 3000 watts of RF power.

• RATED OUTPUT POWER:  2800 watts minimum
• INPUT FOR RATED OUTPUT:   1.0 milliwatts maximum
• POWER OUTPUT @ 3dB compression:
  • Nominal:   3000 watts
  • Minimum:   2200 watts
• POWER OUTPUT @ 1dB:
  • Nominal:   2500 watts
  • Minimum:   1750 watts
• FLATNESS:
  • ±2.5 dB maximum
  • ±0.8 dB with internal leveling
• FREQUENCY RESPONSE:   80-1000 MHz instantaneously
• GAIN (at maximum setting):   65 dB minimum
• GAIN ADJUSTMENT (continuous range):   18 dB minimum
• INPUT IMPEDANCE:   50 ohms, VSWR 2.0:1 maximum
• OUTPUT IMPEDANCE:   50 ohms nominal
• MISMATCH TOLERANCE     100% of rated power without foldback up to 6.0:1 mismatch above which may limit to 1500 watts reflected power. Will operate without damage or oscillation with any magnitude and phase of source and load impedance.
• MODULATION CAPABILITY:   Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
• HARMONIC DISTORTION:   Minus 20 dBc maximum at 2150 watts
• THIRD ORDER INTERCEPT POINT:   72 dBm typical
• RF POWER DISPLAY:   0-4500 watts
• PRIMARY POWER (specify voltage)
• 200-250 VAC, Delta Connected (4 wire)
• 360-435 VAC, Wye Connected (5 wire)
• 50/60 Hz, 3 phase
• 37 kVA Maximum
• CONNECTORS
• RF input:   Type N female on front panel
• RF output:   Type 1 5/8 EIA on rear
• External leveling inputs:   Type BNC female on front panel
• Pulse modulation input:   Type BNC female on front panel
• Detected RF output:   Type BNC female on front panel
• Safety interlock:   15 pin female subminiature D on rear panel
• Remote control:   24 Pin female GPIB/IEEE-488 and 9-pin RS-232 connectors on rear panel
• Remote control (fiber optic):   ST connector. Tx and Rx RS-232
• COOLING:   Forced air (self contained fans) Enters front and bottom
• WEIGHT (approximate):   1453 kg (2625 lb)
• SIZE (WxHxD) (4 cabinets):   272 x 158 x 160 cm (107 x 62 x 63 in) (See outline drawing #10023130)