|
The Model 150A100B amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 150A100B, when used with an RF sweep generator, will provide a minimum of 150 watts of swept power.
-
RATED POWER OUTPUT: 150 watts
-
INPUT FOR RATED OUPUT: 1.0 milliwatt maximum
-
POWER OUTPUT @ 3db COMPRESSION
-
Nominal: 220 watts
-
Minimum: 180 watts
-
POWER OUPUT @ 1db COMPRESSION
-
Nominal: 155 watts
-
Minimum: 125 watts
-
FLATNESS: ± 1.5 dB maximum
-
FREQUENCY RESPONSE: 10 kHz - 100 MHz instantaneously
-
GAIN: 52 dB minimum
-
GAIN ADJUSTMENT RANGE: 18 dB minimum
-
INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum
-
OUTPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum
-
MISMATCH TOLERANCE 100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load impedance.
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
NOISE FIGURE (above 1.0 MHz): 6 dB typical
HARMONIC DISTORTION: Minus 20 dBc maximum at 125 watts
THIRD ORDER INTERCEPT POINT: 58 dBm typical
PRIMARY POWER
REMOTE INTERFACES: IEEE-488, RS-232
CONNECTORS
REMOTE CONTROL
REMOTE INTERLOCK: 15 Pin Subminiature D
COOLING: Forced air (self contained fans)
|
