|
The Model 150A400 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 150A400, when used with an RF sweep generator, will provide a minimum of 150 watts of swept power.
-
RATED POWER OUTPUT: 150 watts minimum
-
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
-
POWER OUTPUT @ 3dB COMPRESSION
-
Nominal: 155 watts
-
Minimum: 130 watts
-
POWER OUTPUT @ 1dB COMPRESSION
-
Nominal: 125 watts
-
Minimum: 100 watts
-
FLATNESS: ±1.5 dB maximum
-
FREQUENCY RESPONSE: 100 kHz - 400 MHz instantaneously
-
GAIN: 52 dB minimum
-
GAIN ADJUSTMENT RANGE: 20 dB minimum
-
INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum
-
OUTPUT IMPEDANCE: 50 ohms nominal
- MISMATCH TOLERANCE 100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load impedance.
- MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
- HARMONIC DISTORTION: Minus 20 dBc maximum at 100 watts
- THIRD ORDER INTERCEPT POINT: 58 dBm typical
- PRIMARY POWER: 90-135/180-270 VAC auto ranging 47-63Hz, single-phase. 1000 watts maximum
- REMOTE INTERFACES: IEEE-488, RS-232
- CONNECTORS
- RF: See Model Configurations
- Remote Control
- IEEE-488: 24 pin female
- RS-232: 9 pin subminiature D female
- COOLING: Forced air (self contained fans)
- REMOTE INTERLOCK: 15 pin subminiature D
|
