|
The Model 100A250A amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required.
-
RATED OUTPUT POWER: 100 watts
-
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
-
POWER OUTPUT @ 3dB compression
-
Nominal: 157 watts
-
Minimum: 125 watts
-
POWER OUTPUT @ 1dB compression
-
Nominal: 107 watts
-
Minimum: 75 watts
-
FLATNESS: ± 1.5 dB maximum
-
FREQUENCY RESPONSE: 10 kHz - 250 MHz instantaneously
-
GAIN (at maximum setting): 50 dB minimum
-
GAIN ADJUSTMENT (continuous range): 18 dB minimum
-
INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum
-
OUTPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum
-
MISMATCH TOLERANCE 100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load impedance.
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
NOISE FIGURE (above 1.0 MHz): 10 dB typical
HARMONIC DISTORTION: Minus 20 dBc maximum at 75 watts
THIRD ORDER INTERCEPT POINT: 58 dBm typical
PRIMARY POWER
REMOTE INTERFACES:
CONNECTORS
- RF input: See Model Configuration
REMOTE CONTROL
- IEEE-488: 24 pin female
- RS-232: 9 pin Subminiature D (female)
REMOTE INTERLOCK: 15 pin subminiature D
COOLING: Forced air (self contained fans)
|
