The Model 100A400 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 100A400, when used with an RF sweep generator, will provide a minimum of 100 watts of swept power.

• RATED POWER OUTPUT:   100 watts minimum
• INPUT FOR RATED OUTPUT:   1.0 milliwatt maximum
• POWER OUTPUT @ 3dB COMPRESSION
  • Nominal:   130 watts
  • Minimum:   100 watts
• POWER OUTPUT @ 1dB COMPRESSION
  • Nominal:   100 watts
  • Minimum:   75 watts
• FLATNESS:   ± 1.5 dB maximum
• FREQUENCY RESPONSE:  100 kHz - 400 MHz instantaneously
• GAIN:   50 dB minimum
• GAIN ADJUSTMENT RANGE:   20 dB minimum
• INPUT IMPEDANCE:   50 ohms, VSWR 1.5:1 maximum
• OUTPUT IMPEDANCE:   50 ohms, VSWR 2.0:1 maximum
• MISMATCH TOLERANCE   100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load impedance.
• MODULATION CAPABILITY:   Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
• HARMONIC DISTORTION:   Minus 20 dBc maximum at the specified minimum 1dB compressed power
• THIRD ORDER INTERCEPT POINT:   58 dBm typical
• PRIMARY POWER
  • 90-135/180-270 VAC auto ranging 47-63Hz, single-phase.
  • 1000 watts maximum
• REMOTE INTERFACES:   IEEE-488, RS-232
• CONNECTORS
  • RF:   See Model Configurations
  • Remote Control
    • IEEE-488:   24 pin female
    • RS-232:   9 pin subminiature D female
• COOLING:   Forced air (self contained fans)
• REMOTE INTERLOCK:   15 pin subminiature D