The Model 100W1000B is a portable, self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Push-pull circuitry is utilized in all high power stages in the interest of lowering distortion and improving stability. The Model 100W1000B, when used with a sweep generator, will provide a minimum of 100 watts of RF power.

• RATED OUTPUT POWER:   100 watts
• INPUT FOR RATED OUTPUT:   1.0 milliwatt maximum
• POWER OUTPUT @ 3dB compression
  • Nominal:   123 watts
  • Minimum:   100 watts
• POWER OUTPUT @ 1dB compression
  • Nominal:   95 watts
  • Minimum:   75 watts
• FLATNESS
  • ±2.0 dB maximum
  • 1.5 dB typical
  • ±0.8 dB with internal leveling
• FREQUENCY RESPONSE:   1-1000 MHz instantaneously
• GAIN (at maximum setting):   50 dB minimum
• GAIN ADJUSTMENT (continuous range)
  • 18 dB minimum
  • (4096 steps remote)
• INPUT IMPEDANCE:   50 ohms, VSWR 2.0:1 maximum
• OUTPUT IMPEDANCE:   50 ohms nominal
• MISMATCH TOLERANCE    Will operate without damage or oscillation with any magnitude and phase of source and load impedance. Will limit reflected power to 100 watts.
• MODULATION CAPABILITY:   Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal.
• HARMONIC DISTORTION:    Minus 20 dBc maximum at 80 watts
• THIRD ORDER INTERCEPT POINT:   58 dBm typical
• RF POWER DISPLAY:   0-200 watts
• PRIMARY POWER (user must specify)
  • 90 - 264 VAC
  • 40/400Hz, single phase
  • 1200 watts maximum
• CONNECTORS
  • RF:   See Model Configurations
  • REMOTE INTERFACES
    • IEEE-488:   24 pin female
    • RS-232:   9 pin Subminiature D (female)
  • ALC & PULSE:   Type BNC on front panel
• SAFETY INTERLOCK:   15 pin Subminiature D
• COOLING:   Forced air (self contained fans)