|
The Model 200S1G4A is a portable, self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Push-pull circuitry is utilized in all high power stages in the interest of lowering distortion and improving stability. The Model 200S1G4A, when used with a sweep generator, will provide a minimum of 200 watts of RF power. -
RATED OUTPUT POWER: 200 watts minimum -
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum -
POWER OUTPUT @ 3dB COMPRESSION -
Nominal: 230 watts -
Minimum: 180 watts -
POWER OUTPUT @ 1dB COMPRESSION -
Nominal: 210 watts -
Minimum: 160 watts -
FLATNESS -
FREQUENCY RESPONSE: 0.8-4.2GHz instantaneously -
GAIN (at maximum setting): 53 dB minimum -
GAIN ADJUSTMENT: 15 dB minimum -
INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum -
OUTPUT IMPEDANCE: 50 ohms nominal -
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal. -
HARMONIC DISTORTION: Minus 20 dBc maximum at 200 watts -
THIRD ORDER INTERCEPT POINT: 64 dBm typical -
RF POWER DISPLAY: Digital, forward and reflected -
PRIMARY POWER -
120-240VAC -
50/60 Hz, single phase -
2150 watts -
CONNECTORS -
RF Connectors: See Model Configurations -
External Leveling Inputs: Type BNC female on front panel -
Pulse Modulation Input: Type BNC female on front panel -
Detected RF output: Type BNC female on front panel -
Safety interlock: 15 pin female subminiature D on rear panel -
Remote computer interface: IEEE-488 (GPIB)& RS-232 connector on rear panel -
Remote Computer Interface (Fiber Optic): ST Conn Tx and Rx RS-232 -
Operate Interface: 25-pin subminiature D on rear panel -
IEEE-488 (GPIB) INTERFACE & RS-232: Allows control and monitoring of all front panel controls except keylock position control - COOLING: Forced air (self contained fans)
|
