|
The Model 1000T2G8B is a self contained, forced air cooled, broadband traveling wave tube (TWT) microwave amplifier designed for applications where instantaneous bandwidth, high gain and high power output are required. Reliable TWT subsystems provide a conservative 1000 watts minimum over most of the frequency range at the amplifier output connector. Stated power specifications are at fundamental frequency. -
POWER (fundamental), CW, @ OUTPUT CONNECTOR -
Nominal: 1100 watts -
Minimum: 900 watts minimum, 2.5–2.7GHz. -
1000 watts minimum 2.7–7.5GHz. -
Linear @ 1 dB Compression: 250 watts minimum -
FLATNESS -
FREQUENCY RESPONSE: 2.5–7.5 GHz instantaneously -
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum -
GAIN (at maximum setting): 60 dB minimum -
GAIN ADJUSTMENT (continuous range): 35 dB minimum -
INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum -
OUTPUT IMPEDANCE: 50 ohms, VSWR 2.5:1 typical -
MISMATCH TOLERANCE: Output power foldback protection at reflected power exceeding 200 watts. Will operate without damage or oscillation with any magnitude and phase of source and load impedance. May oscillate with unshielded open due to coupling to input. Should not be tested with connector off. -
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal. AM peak envelope power limited to specified power. -
NOISE POWER DENSITY -
HARMONIC DISTORTION: Minus 15 dBc maximum, Minus 17 dBc typical -
PRIMARY POWER: See Model Configuration -
CONNECTORS -
RF input: Type N female -
RF output: See Model Configuration -
RF output sample ports (forward and reflected): Type N female -
GPIB: IEEE-488 female on rear panel -
Interlock: DB-15 female on rear panel -
COOLING: Forced air (self contained fans), air entry and exit in rear. -
WEIGHT (approximate): 295 kg (650 lb) - SIZE (WxHxD): 56 x 160 x 82.3 cm (22.1 x 63 x 32.4 in)
|
