|
The Model 5000A3 is a self-contained, air-cooled, broadband, completely solid state amplifier designed for applications where instantaneous bandwidth and high gain are required. The Model 5000A3 when used with an RF sweep generator, will provide a minimum of 5000 watts of swept power.
-
RATED OUTPUT POWER: 5000 watts, 10 kHz–3 MHz
-
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
-
POWER OUTPUT @ 1 dB COMPRESSION: 2500 watts minimum
-
FREQUENCY RESPONSE: 10 kHz-3 MHz instantaneously
-
GAIN (at maximum setting): 67 dB minimum
-
FLATNESS: ± 1.0 dB maximum
-
GAIN ADJUSTMENT (continuous range): 20 dB minimum
-
INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum
- OUTPUT IMPEDANCE: 50 ohms, nominal
-
MISMATCH TOLERANCE: 100% rated power without foldback up to 6.0:1 mismatch above which may limit to 2500 watts reflected power.
-
MODULATION CAPABILITY: Faithfully reproduces AM, FM or Pulse modulation appearing on input signal.
-
HARMONIC DISTORTION: Minus 20 dBc maximum at 2500 watts power output.
-
THIRD ORDER INTERCEPT POINT: 74 dBm typical
-
RF POWER DISPLAY: Forward and Reverse
-
PRIMARY POWER
-
200-240 VAC Delta (4 wire), Wye compatible
-
346-416 VAC, Wye (5 wire)
-
400-480 VAC Delta (4 wire), Wye compatible
-
47-63 Hz, 3 phase
-
(user must specify)
-
20,000 watts maximum at .95 P.F. typical
-
CONNECTORS
-
RF Input: Type N female on rear panel
-
RF Output: Type EIA 1 5/8 male on rear panel
-
Detected RF: Type BNC female on front panel, Forward/Reverse, 0-10Vdc
-
Remote Control: 24 pin female GPIB/IEEE-488 connector on rear panel, RS-232, USB, Ethernet
-
Safety Interlock: 15 pin female Type D on rear panel
-
IEEE-488 (GPIB) INTERFACE: Allows control of all amplifier functions and monitoring of all status indications via standard GPIB/IEEE-488 commands
-
COOLING: Forced air (self contained fans)
-
DIMENSIONS (H x W x D): 112.42 x 168 x 67.15 cm (44.26 x 66.18 x 26.44 in)
- WEIGHT (approximate): 567 kg (1250 lbs)
|
