|
The Model 10,000A250A is a self-contained, air-cooled, broadband, completely solid state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull MOSFET circuitry is utilized in all high power stages in the interest of lowering distortion and improving stability.
-
RATED OUTPUT POWER
-
10,000 watts, 100 kHz – 100 MHz
-
10,000 – 6,000 watts, 100 MHz – 250 MHz
-
(derating slope of 26.66 watts / MHz)
-
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
-
POWER OUTPUT @ 3 dB COMPRESSION
-
9000 watts, 100 kHz–100MHz
-
9000–5000 watts, 100MHz–250MHz
-
(derating slope of 26.6 watts/MHz)
-
POWER OUTPUT @ 1 dB COMPRESSION
-
7,000 watts, 100 kHz - 100 MHz
-
7,000 - 3,000 watts, 100 MHz – 250 MHz
-
(derating slope of 26.66 watts / MHz)
-
FREQUENCY RESPONSE: 100 kHz - 250 MHz instantaneously
-
GAIN (at maximum setting): 70 dB minimum
-
FLATNESS
-
GAIN ADJUSTMENT (continuous range): 20 dB minimum
-
INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum
-
OUTPUT IMPEDANCE: 50 ohms, VSWR 2.5:1 maximum
-
MISMATCH TOLERANCE: 100% rated power without foldback up to 6.0:1 mismatch above which may limit to 5,000 watts reflected power, from 100 kHz to 100 MHz. Limited to 2,000 watts reflected power from 100 MHz to 250 MHz
-
MODULATION CAPABILITY: Will faithfully reproduce AM, FM or Pulse modulation appearing on the input signal.
-
HARMONIC DISTORTION: Minus 20 dBc maximum at 6000 watts
-
THIRD ORDER INTERCEPT POINT: 77 dBm typical
-
RF POWER DISPLAY: 0 - 15,000 watts full scale
-
PULSE MODE GATING CHARACTERISTICS
-
Signal (into 50 ohms): +2.0 to 6.0 VDC
-
Rise Time: 0.5 microseconds maximum
-
Fall Time: 0.5 microseconds
-
RF RISE/FALL TIME: 10 nanoseconds maximum
-
PRIMARY POWER
-
200-240 VAC Delta (4 wire), Wye compatible
-
346-416 VAC, Wye(5 wire)
-
400-480 VAC Delta (4 wire), Wye compatible
-
47-63 Hz, 3 phase
-
(User must specify) Note that in Wye configurations neutral may be used only for low-power circuits
-
40,000 watts maximum at .95 P.F. typical
-
CONNECTORS
-
RF Input: Type N female on rear panel
-
RF Output: Type EIA 1 5/8 male on rear panel
-
External Leveling Inputs: Type BNC female on front panel
-
Pulse Modulation Inputs: Type BNC female on front panel
-
Detected RF Output: Type BNC female on front panel
-
Remote Control : 24 pin female GPIB/IEEE-488 and 9-pin RS-232 connectors on rear panel
-
Remote Control (fiber optic): ST connector. Tx and Rx RS-232.
-
Safety Interlock: 15 pin female Type D on rear panel
-
Forward Power Sample Port (-70 dBc) : Type N female on rear panel
-
Reverse Power Sample Port (-70 dBc): Type N female on rear panel
-
IEEE-488 (GPIB) and RS-232 INTERFACES: Allow control of all amplifier functions and monitoring of all status indications via standard GPIB / IEEE-488 commands or RS-232 commands
-
COOLING: Forced air (self contained fans)
-
WEIGHT (maximum): 816 kg (1800 lb)
- SIZE (W x H x D): 142.3 x 182.9 x 88.9 cm (56 x 72 x 35 in)
|
