|
The Model 540S1G4 is a self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Quadrature coupled circuitry is utilized in all high power stages in the interest of lowering distortion and improving stability. The Model 540S1G4, when used with a sweep generator, will provide a minimum of 540 watts of RF power. -
RATED OUTPUT POWER: 0.8 – 4.2 GHz: 540 watts minimum -
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum -
POWER OUTPUT @ 3 dB COMPRESSION -
Nominal: 585 watts -
Minimum: 485 watts -
POWER OUTPUT @ 1dB COMPRESSION -
Nominal: 535 watts -
Minimum: 430 watts -
FLATNESS -
FREQUENCY RESPONSE: 0.8 - 4.2 GHz instantaneously -
GAIN (at maximum setting): 57.4 dB minimum -
GAIN ADJUSTMENT: 15 dB minimum -
INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum -
OUTPUT IMPEDANCE: 50 ohms nominal -
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal -
HARMONIC DISTORTION: Minus 20 dBc maximum at 475 watts -
THIRD ORDER INTERCEPT POINT: 67 dBm typical -
RF POWER DISPLAY: Digital, forward and reflected -
PRIMARY POWER -
200-240 VAC -
50/60 Hz, single phase -
6850 watts -
CONNECTORS -
RF input: Type N female on front panel -
RF output: Type 7/8 EIA on rear panel -
External leveling inputs: Type BNC female on front panel -
Pulse modulation input: Type BNC female on front panel -
Detected RF output: Type BNC female on front panel -
Safety Interlock: 15 pin female subminiature D on rear panel -
Remote computer interface: 24 pin female IEEE-488.2 (GPIB) connector on rear panel -
Remote computer interface (fiber optic): ST Conn Tx and Rx RS-232 -
IEEE-488 (GPIB) INTERFACE & RS-232: Allows control and monitoring of all front panel controls except keylock position control - COOLING: Forced air (self contained fans) enters front and bottom
|
