|
The Model 150A250 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 150A250, when used with an RF sweep generator, will provide a minimum of 150 watts of swept power.
-
RATED POWER OUTPUT: 150 watts minimum
-
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
-
POWER OUTPUT @ 3dB COMPRESSION
-
Nominal: 180 watts
-
Minimum: 155 watts
-
POWER OUTPUT @ 1dB COMPRESSION
-
Nominal: 150 watts
-
Minimum: 120 watts
-
FLATNESS: ± 1.5 dB maximum
-
FREQUENCY RESPONSE: 100 kHz - 250 MHz instantaneously
-
GAIN: 52 dB minimum
-
GAIN ADJUSTMENT RANGE: 20 dB minimum
-
INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum
-
OUTPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum
-
MISMATCH TOLERANCE 100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load impedance.
-
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
-
HARMONIC DISTORTION: Minus 20 dBc maximum at 120 watts
-
THIRD ORDER INTERCEPT POINT: 58 dBm typical
-
PRIMARY POWER
-
REMOTE INTERFACES: IEEE-488, RS-232
-
CONNECTORS
-
RF input: Type N female
-
RF output: Type N female
- Remote Control
-
COOLING: Forced air (self contained fans)
-
REMOTE INTERLOCK: 15 pin subminiature D
-
WEIGHT, maximum: See Model Configuration
-
SIZE (WxHxD): See Model Configuration
|
