|
Chroma's 62000B Series of Modular DC Power Supplies offer many unique features for Burn-in and plating/electrolysis applications. The features include a N+1 redundancy, high power densities, hot-swappable maintenance, remote ON/OFF and programmable control via the CAN bus.
The 62000B family offers 5 types of power module with ranging from 1 V to 150 V, current from 10 A to 90 A, and offers two mainframe type of six and three position. The six position mainframe can envelop in up to six power modules paralleled operation for 9 kW power output. The 62000B can easily parallel up to fourteen mainframe to 120 kW with current sharing and CAN bus control for bulk power applications.
The 62000B Modular DC Power Supplies are very cost effective, with high power density and low current ripple. These instruments have been designed for burn-in applications such as the LCD panels, DC-DC converters, power inverters, notebook computers, battery chargers and many other types of electronic devices.
Modern power factor correction circuitry is incorporated in the 62000B providing an input power factor above 0.98 to meet the IEC requirements. This PFC correction circuity not only reduces the input current draw, it also greatly reduces the generation of input current harmonics. Optional graphic Soft Panels and CAN bus control allow for control and monitoring of the power system using an easy to use graphical interface.
Equipped with the functionality of N+1 redundancy and hot-swap, the 62000B Series of modular DC power supplies are most applicable for 24 hours non-stop applications such as the SMD plating production lines, as well as product life burn-in test for IT products like DC converters, LCD backlight inverters and routers. For continuous operation applications the modular hot-swap design allows engineers to replace the failure unit on-site without shutting down the entire system.
The 62000B modular power supplies are capable of providing high power output up to 120KW/2000A with minimal specification degradation via CSU(Control & Supervisor Unit). Each chassis is designed to accommodate a maximum of 9KW and include current sharing capability to ensure system stability. In addition, for convenient control of even large power systems, a CSU is provided to set and display output and protection circuits via a standard CAN bus communication protocol.
- Voltage range: 1 ~ 150V
- Current range: 0 ~ 2000A (System)
- Power range: 1.5kW per module up to 120kW per system
- N+1 Redundancy
- High Power Density (464 mW / cm3 = 7.13 W/In3)
- Hot-swappable
- Ideal for Burn-in & Plating
- Remote Sense
- Remote ON / OFF
- CAN BUS Control
- DC OK Signal Output
|
